1.AVD-KP1 Keypad
2.Power: Turns the zone ON an OFF. Can be programmed with IR codes or sequences.
3.Select (Call): This bottom can be use for selected the system function of each zone, and also can be use as for
panic call button (hold 3 sec)
4.Remote (IR Sensor): The keypad gas build-in receiver for complete wireless control , also can be receives IR
from hand-held remotes to control both source components and the AVD-800P system.
5.LED Display: When the zone power is ON, the LED will indicate the selects source, zone volume level.
6.Up: Increases zone source/volume/treble/bass, depends which function LED indicated.
7.Down: Decreases zone source/volume/treble/bass, depends which function LED indicated.
8.Vol: This LED lights to indicate when the volume function has be select
9.Function: The function led show the connection well with the main unit AVD-800p by the cables
10.Call: This LED lights to indicate when the Call function has be turn on.
11.Treble: This LED lights to indicate when the treble function has be select
12.Bass: This LED lights to indicate when the bass function has be select.
13.Busy:When the Busy LED came to light, it show that the control circuitry was busy, if on this station,
the operation of keypad or remote control will be incorrectness.
Figure 6: Keypad Panel Features And Functions
The AVD-800P AVD-KP1 Keypad controllers contain the selected sources by simply pressing one of the
keypads. All buttons are made by soft rubber LED back lights. The center of keypad is a multi-function
cursor array for controlling source/zone components selection; adjust zone bass/treble/volume, and also
feature IR pass-though and conrmation.
Figure 7: Keypad Installation
Keypad mounting for the AVD-KP1 has no need a junction box, which can be mounted on
drywall, button board or other surfaces covering a hollow wall.
8
10
3
9
1
11
2
4
7
6
13
12
5
CAT-5
RJ45
wall
14
15
18
16
17
14.Controller Terminal: RJ45 Jack connects Keypad to zone keypad input on AVD-800P controller via
CAT5 cable.
15.Video Output: RCA Jack connects Keypad to TV or Monitor.
16.Camera Scan Switch:
When Open, the camera (Source 7-10) Disable, Camera can not be output from
Keypad and IR Remote Control Camera Scan Key Disable Operation)
When Short, the camera resume to action ( Camera Enable / Disable must be re-power on)
17. Call Tact Switch Connection Jack:
Action as Call Key of IR Remote.
18. Video Gain Control SVR:
Adjust Video output of Keypad, adjustable range 0-+6dB
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji